MyKobold App

Information and Download Guidance

Main features of MyKobold

My Kobold contains important functions for the robot cleaner Kobold VR300, above all:

  • operate VR300 from remote 
  • create up to 3 different floor plans
  • define no go-lines and zones
  • set cleaning schedules
  • get eventual error messages with explanations and instructions
  • send messages for requesting support
  • receive software updates "over the air"
  • see statistics of cleaning results
Before installing the App
  • Check the OS version of your smart device
  • Charge VR300
  • Prepare the password for your local Wi-Fi
Where to get the MyKobold App

Please access the MyKobold App and install it on the smart device you will actually use:

App Store (iOS):

Google Play (Android):
App Information (iOS)
  • File size: 82.2 MB
  • Current version: 3.6.1
  • Compatibility: iOS 14.0 or higher
  • Last updated: 2023/11/30
App Information (Android)
  • File size: 14.6 MB
  • Current version: 3.6.0
  • Compatibility: Android 8.0 or higher
  • Last updated: 2023/11/30
MyKobold App installation/setting

Please refer to the pdf-files below:

Instructions for downloading MyKobold App

Instructions for connecting Kobold VR300 with your local Wi-Fi

The latest VR300 Software version is 4.6.4-44. If you have an older version you can download here:

Special tipps

Several family members want to use MyKobold App on their smart device

It is not possible to open multiple accounts for the same VR300. Each VR300 has to be allocated to one specific account.

For using the MyKobold App on different smart devices, please download the App to each smart device and log in with the same email address and with the same password on every smart device.

Resetting Kobold VR300

To reset VR300 and the Wi-Fi connection might be necessary in the following cases:

  • To use a different Wi-Fi connection (example: for moving VR300 to a different place)
  • To solve a problem with VR300 (to reset VR300 might help if error messages pop up; if there is no other solution it is worthwhile to try a reset)

To reset VR300

  • first press the right side of the bumber
  • keep pressed and additionally press the green start button
  • keep both pressed for a few moments until all LED lights are off.

If you then turn on VR300 again, after a while the Wi-Fi LED light should blink slowly. Then the reset was successful, and you can connect VR300 again to the Wi-Fi. If the Wi-Fi LED light is blinking rapidly, the reset was not successful. In this case, please repeat the procedure.